Microfluidics Mixing Using Surface Acoustic Waves (SAW). Gonzalo Almanza Álvarez, (2019).
Fabrication of nanoplasmonic sensor device using Electron Beam Lithography (EBL) and optimization performance for submicron particle detection. Diego Sanchez Saldaña (2018).
Mapping of temperature impacts for the RQ-20 PUMA AE military unmanned aerial vehicle. Taksdal, Sigbjørn Falk (2018)
Influence of fluids properties and droplet impinging height on Leidenfrost phenomena over a plain silicon surface. Gonzalez Recio, Daniel Tomas (2017)
Study of impacting droplet on plain and micro-nano enhanced surfaces using Electron Beam Lithography (EBL). Sanchez Saldana, Diego (2017)
Design, Fabrication and Testing of Micro- Nanoscale Thin-Film Resistance Temperature Detectors. Gulliksen, Christian Georg Bauge (2017)
Design and fabrication of micro-nano enhanced surfaces for controlling Leidenfrost point. Grøstad, Eivind (2016)
Numerical simulation of a droplet-film collision using a phase-field approach , Erik O. Tengs (2016).
Experimental and numerical investigation of oil-water dispersions , Karoline Tresvik (2016).
Visualization of condensation over micro-structured surfaces , Raul Ciria Aylagas (2016).
Design of a test section to study droplet-interface coalescence under shear conditions , Santiago Martinez Santaclara (2016).
Micro-Nano enhanced surfaces for investigation of oil-water separation. Retterstøl, Åsmund Bryne (2015)
Effect of heat flux and external system configuration on pressure drop oscillations in a horizontal pipe , Tina L. Langeland (2015).
Assessment of the potential of small scale LPG technologies. Vestbøstad, Ivar (2014)
Experimental and numerical investigation of oil-water separation. Sørbø, Vegard (2014)
Experimental investigation of the impact in the heat transfer coefficient and pressure drop during boiling flow instabilities. Sørum, Mikkel (2014)
Assessment of the potential of small scale LPG technologies, Vestbøstad, Ivar (2014) .
Water droplets settling in crude oil: effect of neighbouring droplets and temperature , Kamilla Sjursen (2014).
Model for simulating large wave regime in gas-liquid pipe flow , Ole Herman Tanger Kiær (2014).
Numerical study of wave characteristics during density wave oscillations in a horizontal, heated channel , Jørn Lian (2014).
Experimental Study of Density Wave Oscillations.Luis Ugueto (2013).
Experimental analysis of the pressure characteristic cruve of a forced convection boiling flow in horizontal channel. Dejan Doder, (2013).
Study of the parameters to generate different sizes of micro-droplets, Vera Palazon, Antonio Jose (2013).
Experimental study of bubble characteristics and heat transfer in subcooled flow boiling of R-134a. Park, Keun-Soo (2013)
Study of the parameters to generate different sizes of micro-droplets. Vera Palazon, Antonio Jose (2013)
CFD study of a rotating gas-liquid separator. Stene, Mari (2013)
Experimental study of density waves oscillations. Ugueto, Luis (2013)
Computational User Support Tool for Decision Making Processes. Gulliksen, Caroline Bauge (2013)
Experimental and Numerical Investigation of a Reversible Cyclone. Storaas, Erik Sævdal Alvestad, Sindre (2013)
Experimental and modeling study of the droplet dynamics related to liquid-liquid separators. Bjerknes, Jenny Victoria(2013)
Experimental analysis of the pressure characteristic curve of a forced convection boiling flow in single horizontal channel. Doder, Dejan (2013)
Analysis of unconventional natural gas resources and possible monetization alternatives. Øverland, Mads Vegard(2012)
Evaluation and Selection of the Precooling Stage for LNG Processes. Majzoub, Mohamad (2012)
Decision Making Methodology for the Selection of Gas-liquid Separators. Sanchez Perez, Carlos Eduardo (2012)
Study of the Droplet-Interface Dynamics Related to Liquid-Liquid Separators. Sveier, Marthin (2012)
Study of droplet-wire fragmentation related to gas liquid separators. Thomassen, Jørgen (2012)
Evaluation of novel processes for removal of gas contaminants. Martinsen, Simen Haukås (2012)
Modeling and Optimization of LNG Processes. Ødegård, Eirik Tonatiuh (2012)
Modeling and Optimization of LNG Processes, Ødegård, Eirik Tonatiuh (2012).
Analysis of unconventional natural gas resources and possible monetization alternatives,Øverland, Mads Vegard (2012).
Evaluation of split ratio of plug flow at a meso-scale T-junction , Andre Wolden (2012). Co-supervisor: Prof: Sang Yong Lee, KAIST, Korea.
Modeling of a centrifugal separator for dispersed gas-liquid flows , Gisle O. Tviberg Monsen (2012).
Breakage and coalescence mechanisms in oil/water gravity separators. Heimdal, Lars (2011)
Design and economical evaluation of components onboard LNG-FPSOs considering vibration and motion. Kadambamattam, Mithun Thomas (2011)
Sensitivity Analysis of Proposed LNG liquefaction Processes for LNG FPSO. Pwaga, Sultan Seif (2011)
Study droplet-wire impact and its effect in the design of gas scrubbers. Strøm, Andreas Wathne (2009)
Development of Small Scale LNG plants, Rødum, Kristian (2009)
Optimization of Energy and Exergy Consumption in MEG Regeneration Processes. Billington, Henrik Reymert (2009)
Anne-Marte Padøy Mathiesen, (2020). Nanoplasmonic biosensing for exosome and virus detection. Project Thesis. NTNU.
Gonzalo Almanza Álvarez, (2018). Fabricaction of microchannels and an IDT´s using a maskless aligner. Project Thesis. NTNU.
Diego Sanchez Saldaña (2018). Fabrication and optimization of nanoplasmonic sensors using Electron Beam Litography (EBL). Project Thesis. NTNU.
Fabrication and wetting properties of different nano-pillar arrangements , Ximena De Diego Lopez (2015).
Verification and validation of a Navier-Stokes solver based on the spectral element method , Erik O. Tengs (2015).
Design of experimental loop to study wax formation in pipelines , Tina L. Langeland (2014).
Qualitative study of transport of gas with low liquid loading in pipelines , Mari Masdal (2014).
Pressure drop and heat transfer during single-phase flow in a heated minichannel , Alejandro Blanco Hurtado (2014).
Coalescence in clusters of water droplets immersed in oil , Kamilla Sjursen (2013).
Validation of changes in scientific software , Ole Herman Tanger Kiær (2013).
CFD study of water droplets falling in oil during gravitational separation , Jørgen Nordbø (2013).
Parametric study of density waves oscillation in a heated, horizontal channel , Jørn Lian (2013).
Effect of inlet geometry on slug flow in microchannels , Sylvie Bourdelin (2012).
Evolution of slug length distribution in a horizontal small-diameter pipe , Andre Wolden (2011).
Evaluation of gas-liquid separators for off-shore and subsea installations , Gisle O. Tviberg Monsen (2011).
Fundamental mechanisms of density wave oscillations and the effect of subcooling. Dag Stromsvag, (2011).
Fundamental mechanisms of density wave oscillations and the effect of subcooling , Dag Strømsvåg (2011).
Bubble separation in microchannel geometries , Endre Joachim Mossige (2010).
Analysis of pressure drop in a boiling channel , Dag Strømsvåg (2009).
Study of mist flow in a vane pack geometry , Fredrik Carlson & Mauritz Talseth (2009).
Vane pack optimization and rig setup for high pressure testing , Fredrik Carlson & Mauritz Talseth (2008).